TX 4x4
Written quote Get a quote

Toyota Tacoma Lift Kit

A suspension lift kit for the Toyota Tacoma that adds real clearance for 33s, with the upper control arms and geometry correction a coil-over Tacoma needs to still drive like a Tacoma.

A suspension lift kit hardware set laid out on a bright shop apron

Toyota Tacoma Lift Kit at a glance

Two-inch Tacoma spacer lift
$950–$1,800
Two-and-a-half to three-inch Tacoma suspension lift
$1,500–$2,700
Three-inch Tacoma lift with upper control arms
$2,300–$3,700
Four-wheel alignment after the lift
$95–$190

Toyota Tacoma lift kit built around the coil-over

Past two inches, a Tacoma stops being a spacer job. The third-generation truck runs a coil-over up front and a leaf pack out back, and once you chase 33s or a set of 35s the upper control arms run out of camber range and the front driveshaft angle starts to complain. A real Tacoma lift raises both ends together and puts corrected geometry back so the truck still tracks down the expressway.

  • Two to three inches that keeps the Tacoma coil-over in its travel
  • Rear block or add-a-leaf to keep the truck off its bump stops
  • Corrected alignment and steering so it drives like a Tacoma, not a project
A suspension lift kit hardware set laid out on a bright shop apron

Toyota Tacoma lift kit fitment

The front end differs by generation and by trim line, so a kit for an SR5 is not automatically the one a TRD Pro takes. We confirm the year, cab configuration and whether the truck already carries a factory or aftermarket suspension before the arms are ordered.

  • Second-generation Tacoma through the 2015 model year
  • Third-generation Tacoma, 2016 through 2023
  • Fourth-generation Tacoma from 2024 with its new coil-over front
  • Lift of 2 to 3.5 inches depending on tire size
  • Access Cab, Double Cab, two- and four-wheel drive, TRD trims

What the Tacoma lift kit includes

A Tacoma lift is the springs, the shocks and the steering correction together, and the parts list is chosen around how the truck is used rather than copied from a shelf.

  • Front coil-over spacers or replacement coil-overs
  • Rear lift block or an add-a-leaf for the Tacoma leaf pack
  • Longer rear shocks matched to the new travel
  • Upper control arms that restore camber range
  • Carrier-bearing spacer where the rear driveshaft angle needs it
  • Brake-line brackets, bump-stop attention and fresh hardware

How we install a Toyota Tacoma lift kit

The Tacoma goes up on the rack the same way every time, so nothing is guessed and the angles come back into range before the truck leaves.

  1. 1. Confirm the Tacoma generation, cab, drivetrain and target height.

  2. 2. Measure ride height and check the control-arm bushings and ball joints.

  3. 3. Fit the front coil-over and the corrected upper control arms.

  4. 4. Set the rear height with blocks or an add-a-leaf.

  5. 5. Install the longer rear shocks and check the brake lines.

  6. 6. Align camber, caster, toe and thrust to the raised Tacoma.

  7. 7. Road-test, listen for driveshaft vibration and re-torque.

What a Toyota Tacoma lift kit costs

There are three lines on a Tacoma lift bill: the parts, the labor and the geometry work the height drags in, and the last one grows fastest above three inches. Prices move with the year and trim, so read the numbers as ranges and have us quote your truck. Pricing varies by year and trim.

Two-inch Tacoma spacer lift
$950–$1,800 installed
Two-and-a-half to three-inch Tacoma suspension lift
$1,500–$2,700
Three-inch Tacoma lift with upper control arms
$2,300–$3,700
Four-wheel alignment after the lift
$95–$190
Rear add-a-leaf for a loaded Tacoma
$400–$900

What changes once a Tacoma goes up

Climb past three inches and the stock Tacoma arms cannot hold camber, which is the honest reason a lifted truck shimmies and eats the inside edge of its front tires. The corrected arms and the carrier-bearing spacer put the angles back where they belong, so a lifted Tacoma still turns in cleanly and the rear stays smooth under a trailer.

  • Front camber back in range instead of at the edge
  • A rear driveshaft that stays quiet under load
  • A Tacoma that aligns to its own numbers, not the rack's default

From the bay

Questions about this build

How much lift can a Tacoma run without new control arms?

Up to about two inches the stock Tacoma arms still hold camber, so a spacer kit is fine. Past two and a half the ball joints run out of range, and that is when corrected arms stop being optional and start being the only way to align it.

Will a lifted Tacoma vibrate at highway speed?

It can, and the cause is usually the rear driveshaft angle rather than the lift itself. We measure pinion angle and fit a carrier-bearing spacer when the truck needs one, which is how a lifted Tacoma stays smooth at 75 mph.

What tire fits a three-inch Tacoma lift?

A three-inch lift usually clears a 285/70 or a 33 on a Tacoma with the right offset, sometimes a 35 with trimming and a body-mount chop. We check clearance on your truck before the tires are ordered.

Does lifting a Tacoma affect its fuel economy?

The lift costs a little through added frontal area, but the bigger change comes from taller, heavier tires. A modest Tacoma lift on a sensible all-terrain keeps the mileage close; a tall lift on mud tires drinks noticeably more.

Can you lift a two-wheel-drive Tacoma?

Yes, and a two-wheel-drive Tacoma lifts cleanly for stance and clearance. The front parts differ from the 4x4 kit because the coil buckets and spindles are not the same, so we order by the drivetrain you actually have.

How does a lifted Tacoma handle day to day?

A Tacoma lifted correctly handles close to stock, because we keep the steering geometry in range and align to the new height. A truck lifted too high without correction wanders and drones, and that is the version we avoid.

Why Valley drivers bring their trucks here

  • Lift, leveling, wheels and alignment under one roof, corrected and aligned.
  • Written estimate before any part is ordered, with the extras called out.
  • Fitment confirmed on your exact truck before you buy tires or wheels.
  • Road-tested and re-torqued, with a settling check after the first miles.

Request a quote

Tell us your truck and what you want. We reply with a written quote for the build.