TX 4x4
Written quote Get a quote

Toyota Tacoma Leveling Kit

A front leveling kit for the Toyota Tacoma that lifts only the nose, clears a taller front tire and leaves the rear leaf pack and its payload rating exactly as Toyota set them.

A suspension lift kit hardware set laid out on a bright shop apron

Toyota Tacoma Leveling Kit at a glance

Front spacer leveling kit for the Tacoma
$260–$560
Leveling kit with new front shocks
$560–$1,050
Coil-over leveling package
$950–$1,700
Four-wheel alignment after the leveling
$95–$190

Toyota Tacoma leveling kit that lifts the nose, not the load

A stock Tacoma leans nose down once you sight along the rocker panel, because the rear leaf pack sits higher than the front coils. A leveling kit raises only the front of the truck so it reads even, a 265/70 fits without kissing the fender liner and the leaf springs that carry your tools and the dirt bike stay exactly as Toyota built them.

  • Front-only lift that takes the factory rake out of the Tacoma stance
  • Room for a taller front tire on the stock 16- or 17-inch wheel
  • Rear leaf pack and payload left exactly as Toyota rated them
A suspension lift kit hardware set laid out on a bright shop apron

Toyota Tacoma leveling kit fitment

The front suspension changed underneath the sheet metal between the second and third generations, so the spacer that tops a 2014 coil bucket is not the one a 2020 takes. We order by model year, cab and drivetrain, because a TRD Off-Road on Bilstein coils sits a touch different from a base SR5.

  • Second-generation Tacoma, 2005 through 2015
  • Third-generation Tacoma, 2016 through 2023
  • Fourth-generation Tacoma, 2024 and newer with its coil-over front
  • Height range of 1 to 2 inches at the front
  • Access Cab, Double Cab, two- and four-wheel drive

What the Tacoma leveling kit includes

Leveling a Tacoma is a small kit and a careful alignment, not a parts cannon. We correct the camber and caster the spacer introduces and check that the taller front tire clears the cab mount before the truck goes back out.

  • Top-mount strut spacers machined for the Tacoma coil bucket
  • Optional front shocks sized to the new height
  • Caster and camber correction for the raised front
  • Four-wheel alignment to reset toe and thrust
  • Fresh hardware where the stock fasteners are tired
  • Clearance check at full lock and on compression

How we level a Toyota Tacoma

Every Tacoma gets the same order of work so the finished truck tracks straight and the steering wheel sits centered.

  1. 1. Confirm the Tacoma year, cab, drivetrain and trim.

  2. 2. Measure the ride height and inspect the coil buckets and lower ball joints.

  3. 3. Fit the front spacers or coil-overs and torque to Tacoma spec.

  4. 4. Reset camber and caster on the raised front.

  5. 5. Set toe and thrust angle on the rack.

  6. 6. Check tire clearance at the cab mount at full lock.

  7. 7. Road-test, center the wheel and hand back the numbers.

What a Toyota Tacoma leveling kit costs

A front spacer is the least you can spend to change how a Tacoma sits, and the number tracks the kit and whether the front struts get swapped. It moves by year, cab and trim, so take the figures as a guide and ask us to price yours. The price varies by year and trim.

Front spacer leveling kit for the Tacoma
$260–$560 installed
Leveling kit with new front shocks
$560–$1,050
Coil-over leveling package
$950–$1,700
Four-wheel alignment after the leveling
$95–$190
Rear add-a-leaf to match a loaded Tacoma
$350–$800

Why a Tacoma owner levels instead of lifts

Most Tacomas never leave pavement far enough to need a full lift, so leveling earns its keep. It fixes the rake, clears the tire the owner actually wants and leaves the rear leaf pack to do its job under a bed full of gear. The change stays reversible, which matters when a Tacoma is still under a factory service plan.

  • The short bed still sits level with a load on board
  • Nothing touches the rear springs or the driveshaft
  • A reversible change if the truck's job changes later

From the bay

Questions about this build

How much front lift does a Tacoma need for 265/70R17 tires?

About two inches clears a 265/70 on a stock-offset Tacoma wheel, which is why the two-inch spacer is the common pick. A zero-offset wheel eats that margin, so we measure your offset before we promise the fit.

Does leveling a Tacoma hurt its towing?

No. A front-only kit never touches the leaf springs or the rear axle, so the Tacoma keeps its rated tongue weight and payload. If you tow heavy and want the truck to stay level, we add a small rear block the same day.

Will a Tacoma leveling kit void my warranty?

A bolt-on spacer that a shop can reverse is not the same as cutting or welding. Keep the stock parts and we can return the Tacoma to stock, which heads off most warranty arguments at the dealer.

Can you level a two-wheel-drive Tacoma?

Yes, and plenty of Valley two-wheel-drive Tacomas get leveled for the look and the front tire room. The parts differ from the four-wheel-drive kit because the coil buckets are not the same, so tell us the drivetrain.

How long does a Tacoma leveling kit take?

A front spacer on a Tacoma is a morning's work, and we fold the alignment into the same visit so you drive out level and tracking straight instead of booking a second appointment.

Do I need new shocks with a Tacoma leveling kit?

Only if your originals are tired. A two-inch spacer stays inside the stock shock's travel, so used Tacoma struts keep working. Past that, or on a truck with 100,000 miles, fresh front shocks ride noticeably better.

Why Valley drivers bring their trucks here

  • Lift, leveling, wheels and alignment under one roof, corrected and aligned.
  • Written estimate before any part is ordered, with the extras called out.
  • Fitment confirmed on your exact truck before you buy tires or wheels.
  • Road-tested and re-torqued, with a settling check after the first miles.

Request a quote

Tell us your truck and what you want. We reply with a written quote for the build.