Toyota Tundra Leveling Kit
A front leveling kit for the Toyota Tundra that squares the half-ton's stance, clears a larger front tire and keeps the rear leaf pack and the tow rating it was built around.
Toyota Tundra Leveling Kit at a glance
- Front spacer leveling kit for the Tundra
- $300–$650
- Leveling kit with new front struts
- $650–$1,200
- Coil-over leveling package
- $1,100–$1,900
- Four-wheel alignment after the leveling
- $95–$190
Toyota Tundra leveling kit for a squared-up half-ton
The Tundra ships with its tail above its nose, and the gap shows the moment a bigger tire goes on. A front-only level brings the nose up so the half-ton squares off, a 33 slips under the fender, and the leaf pack that takes the tongue weight stays exactly as Toyota set it.
- Front-only lift that squares the Tundra stance
- Clears a 33-inch tire on the stock or near-stock wheel
- Rear leaf pack and tow rating left untouched
Toyota Tundra leveling kit fitment
The Tundra's front strut geometry changed with the third generation, so the spacer that fits a 2021 does not fit a 2022 without different hardware. We confirm the generation, cab and TRD package, because the off-road trucks sit at a different height already.
- Second-generation Tundra, 2007 through 2021
- Third-generation Tundra from 2022 with its coil-over front
- Height range of 1.5 to 2.5 inches at the front
- Two- and four-wheel drive, SR, SR5, Limited, Platinum and TRD trims
What the Tundra leveling kit includes
A half-ton carries more nose weight than a midsize, so the Tundra spacer and the alignment are sized for the load. We add caster correction and check the upper control arm the taller front leans on.
- Front strut spacers machined for the Tundra top plate
- Optional matched front struts sized to the new height
- Caster and camber correction for the raised front
- Four-wheel alignment to reset toe and thrust
- Upper control-arm clearance and bump-stop checks
How we level a Toyota Tundra
Every Tundra follows the same order so the half-ton still drives and tows the way its owner relies on.
-
1. Confirm the Tundra generation, cab, drivetrain and TRD package.
-
2. Record the ride height and inspect the front struts and mounts.
-
3. Install the front spacers and torque to Tundra specification.
-
4. Reset camber and caster on the raised front.
-
5. Set toe and thrust angle on the rack.
-
6. Check control-arm travel and tire clearance.
-
7. Road-test, center the wheel and confirm the numbers.
What a Toyota Tundra leveling kit costs
Leveling a Tundra is the cheap half of a lift, and the price moves with the kit and whether new front struts go in. Figures vary by year, cab and trim, so read them as ranges and let us quote the exact truck.
- Front spacer leveling kit for the Tundra
- $300–$650 installed
- Leveling kit with new front struts
- $650–$1,200
- Coil-over leveling package
- $1,100–$1,900
- Four-wheel alignment after the leveling
- $95–$190
- Rear block to match a loaded Tundra
- $250–$600
Why Valley drivers level a Tundra
A Valley Tundra mostly works, pulling a trailer to a jobsite or a boat toward the coast, so owners want the stance corrected while the towing stays exactly as Toyota rated it. A front level clears the tire, removes the nose-down look and keeps every figure on the door label valid.
- Tongue weight and payload left as Toyota rated them
- The rear leaf pack still does the heavy lifting
- A reversible change for a truck still under service
From the bay
Questions about this build
How much front lift does a Tundra need for 33-inch tires?
About two inches clears a 33 on a Tundra with a stock-offset wheel, and that is the common spacer size. A wide, low-offset wheel eats the margin, so we measure your offset before we promise the fit.
Does leveling a Tundra change its tow rating?
No. A front-only kit leaves the rear leaf springs and the axle untouched, so the factory tow and payload numbers stand. If you tow heavy and want the Tundra to hold level, we fit a small rear block at the same time.
Will a leveling kit fit a third-generation Tundra?
Yes, but with different hardware. The 2022-and-newer Tundra runs a redesigned coil-over front, so we order the parts by generation rather than assume the older spacer carries over.
Can you level a two-wheel-drive Tundra?
Yes. Two-wheel-drive Tundras level cleanly for stance and front clearance, though the kit differs from the four-wheel-drive version because the struts and mounts are not identical. Tell us the drivetrain and we order right.
How long does a Tundra leveling kit take?
A front spacer kit on a Tundra is finished within a few hours, with the alignment in the same visit. You drive out level and aligned rather than booking a second appointment for the angles.
Do I need an alignment after leveling a Tundra?
Yes, every time. Raising the front moves camber and toe and leaves the steering wheel off-center until it is reset. We align to the new height so the Tundra tracks straight and the front tires wear evenly.
Why Valley drivers bring their trucks here
- Lift, leveling, wheels and alignment under one roof, corrected and aligned.
- Written estimate before any part is ordered, with the extras called out.
- Fitment confirmed on your exact truck before you buy tires or wheels.
- Road-tested and re-torqued, with a settling check after the first miles.
Request a quote
Tell us your truck and what you want. We reply with a written quote for the build.