RAM 1500 Leveling Kit
A front leveling kit for the RAM 1500 that squares the half-ton's stance, clears a 33 and works with the coil-spring rear that makes a Ram different from other pickups.
RAM 1500 Leveling Kit at a glance
- Front spacer leveling kit for the RAM 1500
- $300–$620
- Leveling kit with new front struts
- $640–$1,200
- Coil-over leveling setup for the RAM
- $1,100–$1,900
- Four-wheel alignment after the leveling
- $95–$190
RAM 1500 leveling kit for the coil-spring half-ton
The RAM 1500 is the only mainstream half-ton with coil springs at the rear instead of a leaf pack, and that coil ride is part of why people buy one. The truck still leaves the lot with the rear a touch higher than the front. A leveling kit raises only the RAM front so it sits even, a 33 clears the fender and the rear coils keep the comfortable ride and the tow rating the truck was bought for.
- Front-only lift that squares the RAM 1500 stance
- Works around the coil-spring rear rather than a leaf pack
- Rear coils and tow rating left as the factory set them
RAM 1500 leveling kit fitment
The DT Ram from 2019 and the older DS trucks take different front hardware, and a Rebel or an air-suspension truck sits and cycles differently again. We confirm the generation, trim and whether the truck carries the air suspension before ordering the spacer.
- DS-generation RAM 1500, roughly 2009 through 2018
- DT-generation RAM 1500 from 2019
- Height range of 1.5 to 2.5 inches at the front
- Two- and four-wheel drive, Tradesman through Limited, Rebel and air-suspension trucks
What the RAM 1500 leveling kit includes
A Ram leveling kit is a front spacer and a careful alignment, with a look at the coil-spring rear only to confirm the truck still sits level with a load. We correct the angles the spacer moves.
- Front strut or coil spacers machined for the RAM top mount
- Optional matched front struts sized to the new height
- Camber and caster correction for the raised front
- Four-wheel alignment to reset toe and thrust
- Air-suspension and ride-height-sensor checks where fitted
- Road test for pull, rub and a centered wheel
How we level a RAM 1500
Board a Ram and it gets the same treatment each time, so the coil-sprung half-ton keeps its soft ride and still points straight once it is down.
-
1. Confirm the RAM generation, trim and whether it has air suspension.
-
2. Read the ride height, then inspect the front struts and rear coils.
-
3. Install the front spacers and torque to RAM specification.
-
4. Reset camber and caster on the raised front.
-
5. Set toe and thrust angle on the rack.
-
6. Check the ride-height sensors if the truck is air-sprung.
-
7. Road-test, center the wheel and hand back the numbers.
What a RAM 1500 leveling kit costs
Leveling a Ram is inexpensive for the same reason it is on any strut-front half-ton, and the price only climbs if new front struts go in. Numbers differ by year and trim, so read them as ranges and let us quote your truck. Numbers vary by year and trim.
- Front spacer leveling kit for the RAM 1500
- $300–$620 installed
- Leveling kit with new front struts
- $640–$1,200
- Coil-over leveling setup for the RAM
- $1,100–$1,900
- Four-wheel alignment after the leveling
- $95–$190
- Rear coil spacer to fine-tune the Ram
- $240–$560
Why a Ram owner levels
Ram buyers prize the coil-spring ride, and a heavy lift is the fastest way to lose it. Leveling keeps that compromise small: the front comes up, the rear coils stay soft and comfortable, and the truck sits square with a 33 up front. It is the change that fixes the stance without asking the Ram to give up the one thing that sets it apart.
- The smooth coil-spring rear ride kept
- Payload and tow ratings left as rated
- A reversible change for a daily half-ton
From the bay
Questions about this build
Does a RAM 1500 leveling kit work with the coil rear?
Yes, because a front-only kit never touches the rear coil springs. The Ram keeps its smooth coil ride and its ratings, and the level simply takes the rake out of the front so the truck sits square.
Can you level a RAM with air suspension?
Yes, with care. Air-sprung Rams ride on height sensors, so we fit parts that do not disturb them and recheck the ride height after installation. Tell us the truck has air springs and we plan around them.
How much front lift does a RAM 1500 need for 33s?
About two inches clears a 33 on a RAM with the stock-offset wheel, which is the common spacer size. A wide low-offset wheel eats the margin, so we measure your wheels first.
Does leveling a RAM 1500 hurt its tow rating?
No. A front-only kit leaves the rear coils and axle untouched, so the factory tow and payload figures stand. If you tow heavy and want the Ram level loaded, we fit a small rear coil spacer at the same time.
Can you level a two-wheel-drive RAM 1500?
Yes, and two-wheel-drive Rams level cleanly for stance and front room. The front parts differ from the four-wheel-drive truck, so we order by drivetrain and confirm the springs before the kit is ordered.
Do I need an alignment after leveling a RAM?
Always. Raising the front moves camber and toe and leaves the wheel off-center until it is reset. We align to the new height so the Ram tracks straight and the front tires wear evenly across the tread.
Why Valley drivers bring their trucks here
- Lift, leveling, wheels and alignment under one roof, corrected and aligned.
- Written estimate before any part is ordered, with the extras called out.
- Fitment confirmed on your exact truck before you buy tires or wheels.
- Road-tested and re-torqued, with a settling check after the first miles.
Request a quote
Tell us your truck and what you want. We reply with a written quote for the build.