Chevrolet Silverado Leveling Kit
A front leveling kit for the Chevrolet Silverado that removes the factory rake, clears a 33 and preserves the rear leaf pack and the tow rating the half-ton was built around.
Chevrolet Silverado Leveling Kit at a glance
- Basic front spacer kit for the Silverado
- $290–$600
- Spacer kit with new front struts
- $620–$1,150
- Coil-over leveling setup for the Silverado
- $1,050–$1,850
- Four-wheel alignment after the leveling
- $95–$190
Chevrolet Silverado leveling kit for a squared-up half-ton
Every Silverado leaves the plant with the tail an inch or two above the nose. Leveling lifts the front alone, so the half-ton squares up, a 33 tucks under the fender and the nose-down look is gone. The spacer rides above the strut on the Silverado's independent front end, leaving the factory coils, the rear leaf pack and the tow rating as they were.
- Front-only lift that squares the Silverado stance
- The rear leaf pack and the tow rating left alone
- Installed, aligned and road-tested before pickup
Chevrolet Silverado leveling fitment
Silverado strut geometry changed with each generation, so a spacer that fits a 2015 will not fit a 2021 without different hardware. We confirm the generation, trim and whether the truck carries the Z71 or Trail Boss package, because those off-road trucks already sit higher.
- K2-generation Silverado, roughly 2014 through 2018
- T1-generation Silverado from 2019, including the refreshed front
- Height range of 1.5 to 2.5 inches at the front
- Two- and four-wheel drive, WT through High Country, Z71 and Trail Boss
What the Chevrolet Silverado leveling kit includes
A Silverado leveling install is more than a spacer and a torque wrench. We correct the geometry the lift disturbs and verify clearance so the half-ton still drives like the truck its owner relies on.
- Front strut spacers machined for the Silverado top plate
- Optional matched front struts sized to the new height
- Camber and caster correction for the raised front
- Four-wheel alignment to reset toe and thrust
- Brake, ABS and bump-stop clearance checks
- Road test for pull, rub and an off-center wheel
How we level a Chevrolet Silverado
The Silverado job is straightforward, but we run the same sequence so the result is predictable.
-
1. Confirm the Silverado generation, trim and off-road package.
-
2. Measure the ride height and inspect the struts and mounts.
-
3. Install the front spacers and torque to Silverado specification.
-
4. Bring camber and caster back into range.
-
5. Set toe and thrust angle on the rack.
-
6. Check control-arm and brake-line clearance.
-
7. Road-test the Silverado and center the wheel before delivery.
What a Chevrolet Silverado leveling kit costs
A level is the least you can spend to change how a Silverado sits, and the bill tracks the spacer style and whether the front struts get changed. It moves by year and trim, so take the figures as a guide and ask us for your number. Numbers vary by year and trim.
- Basic front spacer kit for the Silverado
- $290–$600 installed
- Spacer kit with new front struts
- $620–$1,150
- Coil-over leveling setup for the Silverado
- $1,050–$1,850
- Four-wheel alignment after the leveling
- $95–$190
- Rear block to keep a loaded Silverado level
- $260–$620
Why Silverado owners level
A Silverado in the Valley earns its keep, pulling a trailer and carrying tools, so owners here want the stance fixed without giving up the towing. A front level clears a 33, kills the nose-down look and keeps every rating on the door jamb intact, which is what matters on a truck that still works.
- Payload and tow ratings left as rated
- A 33 fits the front on the stock wheel
- A reversible change for a work half-ton
From the bay
Questions about this build
How much front lift does a Silverado need for 33s?
About two inches clears a 33 on a Silverado with the stock-offset wheel, which is the common spacer size. A wide, low-offset wheel eats the margin, so we measure your wheels before promising the fit.
Does leveling a Silverado hurt its tow rating?
No. A front-only kit leaves the rear leaf springs and axle untouched, so the factory tow and payload figures stand. If you tow heavy and want the Silverado level loaded, we fit a small rear block at the same time.
Will a leveling kit fit a Trail Boss Silverado?
Yes, but a Trail Boss already sits about two inches higher from the factory, so the net gain is smaller and the hardware differs. We measure the truck first and tell you how much it actually needs.
Do I need an alignment after leveling a Silverado?
Every time. Raising the front moves camber and toe and leaves the wheel off-center until it is reset. We align to the new height so the Silverado tracks straight and the front tires wear evenly across the tread.
Can you level a two-wheel-drive Silverado?
Yes, and two-wheel-drive Silverados level cleanly for stance and front room. The struts differ from the four-wheel-drive truck, so we order by drivetrain and confirm the springs before the kit is ordered.
How long does a Silverado leveling kit take?
A front spacer kit on a Silverado is finished within a few hours, with the alignment in the same visit. You drive out level and aligned rather than booking a second appointment for the angles.
Why Valley drivers bring their trucks here
- Lift, leveling, wheels and alignment under one roof, corrected and aligned.
- Written estimate before any part is ordered, with the extras called out.
- Fitment confirmed on your exact truck before you buy tires or wheels.
- Road-tested and re-torqued, with a settling check after the first miles.
Request a quote
Tell us your truck and what you want. We reply with a written quote for the build.