Chevrolet Colorado Leveling Kit
A front leveling kit for the Chevrolet Colorado that evens the stance of the mid-size truck, clears a 32 and keeps the factory rear springs and payload rating intact.
Chevrolet Colorado Leveling Kit at a glance
- Basic front spacer kit for the Colorado
- $250–$550
- Colorado spacer kit with new front shocks
- $550–$1,000
- Coil-over leveling setup for the Colorado
- $900–$1,600
- Four-wheel alignment after the Colorado leveling
- $90–$180
Chevrolet Colorado leveling kit for an even mid-size stance
The Colorado rolls off the lot with a rear end sitting higher than the front, a rake that turns obvious the moment you fit a taller tire. A leveling kit raises only the Colorado front so the truck sits even, a 32 clears the fenders and the original springs keep the payload rating. Because the Colorado runs an independent front suspension on struts, the right kit is strut-based rather than a block under a leaf.
- Front-only lift that evens the Colorado stance
- Confirms a 32-inch front tire on the stock wheel
- Keeps the factory rear springs and the payload rating
Chevrolet Colorado leveling fitment
Leveling hardware is specific to the Colorado strut mounts and spring seats, so we order by model year and trim rather than a generic number. The second-generation Colorado from 2015 onward and the newer body style both take a front level, but the parts differ between them.
- Second-generation Colorado, 2015 through 2022
- Newer Colorado from 2023 onward with its revised front end
- Height range of 1 to 2 inches at the front
- Two- and four-wheel drive, WT through ZR2
What the Chevrolet Colorado leveling kit includes
A Colorado kit is small, but a proper install is more than dropping in a spacer. We correct the angles the level disturbs so the truck still drives straight down the road.
- Front strut spacers machined for the Colorado top mount
- Optional matched front shocks sized to the new height
- Camber and caster correction for the raised front end
- Four-wheel alignment to reset toe and thrust
- Bump-stop and brake-line clearance checks
- Road test for rub, wander and centered steering
How we level a Chevrolet Colorado
The Colorado job moves quickly, but the same careful sequence keeps it right every time.
-
1. Confirm the Colorado year, trim and the level height you want.
-
2. Inspect the Colorado struts, top mounts and control-arm bushings.
-
3. Install the front spacers and torque every fastener to Colorado spec.
-
4. Correct camber and caster to bring the raised front back into range.
-
5. Set toe and thrust angle on the rack for the leveled Colorado.
-
6. Check tire clearance at full lock and with the suspension compressed.
-
7. Road-test the Colorado and center the steering wheel before pickup.
What a Chevrolet Colorado leveling kit costs
A Colorado level is the cheapest way to alter its stance, though the bill tracks the spacer style and whether the front dampers are swapped. Pricing moves by year and trim, so treat these as ballpark ranges and ask us for your own. The figure varies by year and trim.
- Basic front spacer kit for the Colorado
- $250–$550 installed
- Colorado spacer kit with new front shocks
- $550–$1,000
- Coil-over leveling setup for the Colorado
- $900–$1,600
- Four-wheel alignment after the Colorado leveling
- $90–$180
- Rear block to fine-tune the Colorado stance
- $150–$400
Why Valley owners level the Chevrolet Colorado
The Colorado is a popular mid-size in the Valley because it fits tight parking yet still tows a small trailer and handles a caliche lease road. Leveling it makes room for a 32 up front and takes the factory rake out, so the truck reads as intentional rather than unfinished. Because we leave the rear springs alone, the Colorado keeps the payload rating the owner bought it for.
- Room for a 32-inch front tire on the stock wheel
- Payload and towing ratings left exactly as the factory set
- A simple, reversible change that suits a daily mid-size
From the bay
Questions about this build
Will a leveling kit make my Chevrolet Colorado ride rough?
A matched spacer kit rarely changes the ride much on its own, since the Colorado keeps its factory springs. Paired with fresh front shocks it often rides better than before, because the original struts on a higher-mileage Colorado are usually soft.
How much front lift does a Chevrolet Colorado need for 32-inch tires?
Around two inches clears a 32 on the Colorado in most cases, as long as the wheel offset stays near stock. We measure the fender gap first, because a zero-offset wheel on the Colorado eats into the clearance you gained.
Does leveling a Chevrolet Colorado affect its tow rating?
No, because a front-only kit leaves the Colorado rear springs and axle untouched, so the factory tow and payload figures stand. Hook a heavy trailer, though, and we suggest a small rear block so the leveled Colorado still rides level under load.
Can I level a two-wheel-drive Chevrolet Colorado?
Yes. Two-wheel-drive Colorados level cleanly and are common Valley builds, though the kit differs from the four-wheel-drive version because the struts and mounts are not the same. Tell us the drivetrain and we order the right parts.
How long does a Colorado leveling kit take to install?
A basic front spacer kit on a Colorado is usually done within a few hours, and we include the alignment in the same visit. That way you drive out level and aligned instead of booking a second appointment for the angles.
Do I need an alignment after leveling my Colorado?
Yes, every time. Raising the Colorado front moves camber and toe, and the steering wheel ends up off-center until it is reset. We align to the new height so the Colorado tracks straight and the front tires wear evenly.
Why Valley drivers bring their trucks here
- Lift, leveling, wheels and alignment under one roof, corrected and aligned.
- Written estimate before any part is ordered, with the extras called out.
- Fitment confirmed on your exact truck before you buy tires or wheels.
- Road-tested and re-torqued, with a settling check after the first miles.
Request a quote
Tell us your truck and what you want. We reply with a written quote for the build.